#007: My default Raspberry Pi!

This is how I setup my Raspberry Pi; this is all documented (lots of times!) elsewhere on the interwebs but I'm still going to document here what I do.

This is all the stuff I do before I run an install script from one of my github projects... o.k. I haven't made it yet, but I will. I've already created the start of it with the FinnAngelo/BuildServer project.


Installing Raspbian

  1. Head over to the RaspberryPi Downloads and download Raspbian
  2. You also need to use the Win32-Disk-Imager to install the image into your SD card.
  3. Click Write to write the image to the SD card

Going headless with Putty

  1. Plug the RaspPi onto your network
  2. Find out the IP Address of the Pi
    • I used to use the Advanced IP Scanner but it's easier to just use my router (under mac filtering) - its mac address web page is good enough and anyway, later on I set the ip of the Pi to a static address.
  3. Remote in with ssh using Putty - I use Putty Portable
    • Hostname/IP Address: Your IP address
    • Port: 22
  4. The Raspbian initial login is
    • username: pi
    • password: raspberry

Initial Setup

Here's the basics I always do the first time I run the pi


sudo apt-get update 
sudo apt-get upgrade -y
sudo apt-get dist-upgrade -y
sudo raspi-config 

Here's a bunch of settings for the config:

  • Expand Filesystem to use all boot disk
  • Change your password
  • Internationalization
    • Don't touch Configuring locales
      • it should stay as en-gb.UTF-8
    • Change Timezone - Australia > Melbourne
  • Advanced
    • Update - takes about 2min

After closing the config down


sudo reboot

Written on July 11, 2015